For crimping copper and stainless steel clamping sleeves. Indispensable tool for the installation of pigeon deterrent wire, net and electrical Systems.
Dowel diameter: 6 mm Dowel length (l): 45 mm Nominal drill diameter (d 0): 10 mm Drill hole depth (h 1): 55 mm Effective anchoring depth (h ef): 39.5 mm Torque during anchoring (T inst): 5 Nm Through hole in the component to be connected (d f): 7 mm May only be used in dry indoor conditions For non-cracked concrete, galvanised steel Low force required when setting the dowel Can be loaded immediately – no waiting times No setting tools required Can be set flush with the surface Uniform spreading effect and load distribution due to the triple spreading sleeve Secure installation by applying the specified torque during anchoring Force-controlled/torque-controlled expanding dowel made of electro-galvanised steel Suitable for medium and heavy-duty applications Suitable for fastening: Transfer lines on the floor area where flush mounting is required; steel structures, metal profiles, brackets, base plates, cable trays, pipelines, mounting rails, etc. Can be used in concrete < C20/25, pressure-resistant natural stone and solid brickwork (without approval) The dowel may be used for anchoring under predominantly static or quasi-static loads Single fastening: anchoring in non-cracked concrete May only be used in dry indoor conditions
Dimensions: 24.5 x 24.5 mm Height: 7.1 mm Cable tie, black, UV-resistant: 75 x 2.4 mm The holder can be glued or screwed on. This holder makes it easy to lash the bird protection net to the building. (Screws and adhesive are not included in the scope of delivery)
Sturdy ring clamp pliers made of painted steel. The ring clamp pliers are required when installing nets. The advantages of these pliers are their robust design and easy handling. The large magazine has space for 50 staples. The following staple types can be used: Article W3410 / W3430
High-strength, elastic hybrid structural adhesive Contents: 300 ml Packaging: Cartridge Chemical composition: Hybrid polymer Skin formation time (max.): 40 min Skin formation time min./max.: 30–40 min Curing rate / conditions: 3 mm/day / 23°C and 50% relative humidity, moisture-curing Application temperature min./max.: 5 to 40 °C Temperature resistance min./max.: -40 to +90 °C Temperature resistance, short-term max.: 150 °C Temperature resistance, short-term max. / conditions: 150 °C / after 16 hours Volume change max.: 2 % Max. volume change / condition: 2% / according to DIN 52451 Short-term resistance to: mineral oils, fuels, animal fats, animal oils, vegetable fats, vegetable oils Silicone-free: Yes Solvent-free: Yes PVC-free: Yes VOC-free: Yes Isocyanate-free: Yes UV resistance: Yes Applications For structurally bonded joints subject to dynamic stress, as well as seam and joint sealing in bodywork, vehicle and caravan construction, railway carriage and container construction, metal and plant engineering, air conditioning and ventilation duct construction, the food industry and many more. Instructions Surfaces must be clean, dry and free of grease. For pre-treatment, please refer to the optimisation table in the technical data sheet. Cut off the threaded cap, screw on the nozzle and cut to the desired width. Apply the adhesive using a suitable caulking gun. To benefit from the advantages of thick-film bonding, a minimum adhesive thickness of 3 mm is recommended. Further information can be found on the manufacturer’s website