High-strength, elastic hybrid structural adhesive Contents: 300 ml Packaging: Cartridge Chemical composition: Hybrid polymer Skin formation time (max.): 40 min Skin formation time min./max.: 30–40 min Curing rate / conditions: 3 mm/day / 23°C and 50% relative humidity, moisture-curing Application temperature min./max.: 5 to 40 °C Temperature resistance min./max.: -40 to +90 °C Temperature resistance, short-term max.: 150 °C Temperature resistance, short-term max. / conditions: 150 °C / after 16 hours Volume change max.: 2 % Max. volume change / condition: 2% / according to DIN 52451 Short-term resistance to: mineral oils, fuels, animal fats, animal oils, vegetable fats, vegetable oils Silicone-free: Yes Solvent-free: Yes PVC-free: Yes VOC-free: Yes Isocyanate-free: Yes UV resistance: Yes Applications For structurally bonded joints subject to dynamic stress, as well as seam and joint sealing in bodywork, vehicle and caravan construction, railway carriage and container construction, metal and plant engineering, air conditioning and ventilation duct construction, the food industry and many more. Instructions Surfaces must be clean, dry and free of grease. For pre-treatment, please refer to the optimisation table in the technical data sheet. Cut off the threaded cap, screw on the nozzle and cut to the desired width. Apply the adhesive using a suitable caulking gun. To benefit from the advantages of thick-film bonding, a minimum adhesive thickness of 3 mm is recommended. Further information can be found on the manufacturer’s website